APPLICATION INSTRUCTIONS Read container information and always use PROTECTIVE EYE WEAR !!!-PRESSURIZED CONTAINERS Note: (APPLY TO COOL ENGINE FOR MAXIMUM EFFECTIVENESS) Step #1 Engine Purge Fuel Tank Treatment. 1) Attatch the clear multi adapter to the top of can. 2) Remove the gas cap and insert the end of the clear tube muli adapter into gas tank filler neck past the spring loaded vapor flap. 3) Depress actuator and empty contents into gas tank. Step #2 Engine Fog complete Upper Engine Cleaner 1) Attach the clear multi adapter to the top of can and connect to a vacuum outlet on the intake plenum as close as possible to the air throttle body. The application should be behind the throttle body and below any electrical components. 2) Start engine and idle until engine is running smoothly. With can upright, hold continuously shaking the can untill empty. Although engine should labor, do not allow engine to stall. If stalling occurs, stop appplication, re-start engine immediately, allow idle to return to normal, and continue application process. 3) Turn off engine immediately upon can being empty. Remove clear hose adapter and replace vacuum line. Allow engine to soak for approximately 10 to 15 minutes. 4) While engine is soaking, begin step #3. Step #3 Engine Mist Throttle Body Cleaner 1) While engine is off and soaking, remove the air intake boot at the manifold. If Idle Air Control Motor is located underneath the intake manifold, check to insure the intake runner on IAC Motor is dry. If not, remove and dry completely, then reinstall motor. 2) Open butterfly valve and spray can on both sides of the throttle plate. Use approximately one half of the can. 3) Allow product to soak for a few minutes, then repeat spraying procedure to the throttle plate area to wash away all remaining deposits. Use remainder of can. 4) Re-attach air intake boot and wait for completion of 10 to 15 minute total soak time of Enigne Fog. 5) Start engine and run at approximately 2500 r.p.m. for 2 minutes while snapping accelerator 3 or 4 times. Test Drive vehicle. The 3-Part Engine Fog Kit Complete upper engine cleaning is now complete Copyright 2000-2010, H.D.I. Managemet Inc. Nevada, USA All Rights Reserved, All Logos, Trademarks & Copyrights are property of their respective owners.