Make sure you have proper air ventilation, adhere to all safety practices, and use OSHA approved safety glasses. Make sure that their are at lease two to five (2-5) gallons of gasoline in the fuel tank. Apply Parking Brake. 1) Start the engine and allow it to reach Full operating Temperature. Let run for several to 8 minutes. Turn Off Engine. You are now ready to perform 3-Step Stremeline Dynamics Stages 1,2,or 3 STAGE 1 (Fuel System Cleaner) 2) While the Engine is off , empty the entire contents of FUEL SYSTEM CLEANER (Red Lable) in the fuel tank. 3) STAGE 2 Oil System Cleaner With the engine still OFF, SLOWLY empty the entire contents of STAGE 3 (Oil System Conditioner-Grey Lable) OIL SYSTEM CLEANER into the crankcase oil. Make sure that the oil fill cap is installed back on car. Check the oil level making sure the level is proper. STEP 3 INTAKE-INDUCTION SYSTEM CLEANER 4) Remove a vacuum hose from the PCV Valve, brake power booster or highest convenient vacuum hose from the intake manifold (make sure it does not lead through any plastic tees or check valves) and connect the FI01002 feeder bottle to the hose making sure the brass valve on the feeder kit is closed. Use CAUTION to make sure the feeder kit hose is clear of the radiator fan and exhaust manifold. 5)Connect the other end of the #FI01002 to hood or under hood latch to support the I.V. bottle. Once clipped on hood catch or equivalant, empty entire contents of the Clear Bottle (INDUCTION SYSTEM CLEANER-BLUE LIQUID) into the clear feeder bottle 6) Restart Engine, Adjust the engine speed to 1200 - 1450 RPM except turbo engines which remain at idle, OR you can leave all vehicles at idle, it takes a little longer. DO NOT RUSH, THIS STEP SHOULD TAKE 7 TO 15 MINUTES ! 7) Slowly open the brass valve on the feeder brass valve to allow the INDUCTION SOLUTION cleaner to flow slowly through the vacuum line. The engine may shake during this process. If the engine should stall, close the brass feeder valve, restart the engine and continue. 8) When the entire contents of the feeder bottle or product bottle have been pulled into the engine. Shut off the engine, remove the feeder kit or product bottle, reconnect the vacuum hose and return the engine idle to normal. NOTE: If Lowered emission readings are desired, take them NOW, before the next step. OPTIONAL STAGE STAGE 4 (THROTTLE BODY CLEANING FOAM )is recommended on engines equipped with throttle body fuel injection or a carburetor and will not harm them. (NOTE: DO NOT USE ORDINARY CARBURETOR CLEANER ON NEWER TEFLON-COATED THROTTLE BODY MODELS AS IT IS CAUSTIC AND CAN DAMAGE THEM) 9) With the engine off, disconnect the air intake boot from the throttle body or remove the air cleaner cover from the carburetor. Spray about half of the contents of the THROTTLE BODY CLEANING FOAM can into the throat while working the butterfly valve back and forth. Start the engine and spray the remainder of the can contents into the throttle body or carburetor using short spray bursts. Reconnect the air intake boot or air cleaner and let the engine idle for at least five minutes or drive the car at once. NOTE: The "check engine" light may come on due to the rise of hydrocarbon vapors created during the cleaning process. On 1995 and older vehicles not equipped with OBDII coumputers the light will turn off by itself within 5-45 miles, or you may turn it off with a scanner, or simply pull the negative battery terminal for 30 seconds. This is a safe way to reset the coumputer. Keep in mind you will need to re program some accessories such as clocks and radios. Copyright 2000-2010, H.D.I. Management Inc. Nevada, USA all rights reserved, All logos, Trademarks, & Copyrights are property of their respective owners. |